Locate Model Numbers

Broan Customer Service

Dial: 1-800-558-1711
Hours: M-F 7:30 am - 6 pm CST

IMPORTANT:

About Broan Model Numbers

Some Broan model numbers have an alpha suffix.

Example: 41000-L.

It is important to refer to the exact model number with the alpha suffix when selecting parts, requesting service or speaking to a technical support representative regarding your Broan product.

Register Your Product

Standard Under Cabinet

Label Placement

The model label is located either on the right or left side wall of the range hood canopy.

Allure Under Cabinet

Label Placement

Remove range hood filters by pulling down on the filter tabs. The series number is located either on the back wall of the range hood housing or on the Teflon air pan. (Example...QS1, QS2 or QS3)

Broan Elite Fashion Style

Label Placement

Remove range hood filters. The model label is located on the underside of the canopy behind the filters.

Broan Elite Professional Style

Label Placement

The model label is located on the inside of left wall of the range hood canopy. Filters may need to be removed to access the label.

Island Downdraft

Label Placement

The model label is located on the front of unit beneath the cook top.
Cabinet drawers or shelving may need to be removed to access label.

Standard Bath Fan

Label Placement

Remove the grille by pulling down 2 inches. Reach behind the grille and squeeze the mounting springs to remove the grille. The model label is located in the corner closest to the outlet. Some fans may have the model stamped into the motor plate instead of a printed sticker label.

Mid-Level Bath Fan

Label Placement

Remove the grille by pulling down 2 inches. Reach behind the grille and squeeze the mounting springs to remove the grille. The model label is located on the underside of the motor plate.

Designer Style Bath Fan

Label Placement

Remove the glass lens which is attached by two leaf springs. Use a small flat head screwdriver to pry the glass lens from the grille. Screwdriver can be inserted into one of the small slots on the perimeter of the glass lens. To avoid scratching the surface of the grille the screwdriver can be wrapped in a thin cloth or tissue. Reach over lens and push in on springs to release. Grille is held by two screws along rim or a single nut in the center. The model label is located on the underside of the motor plate.

Combination Bath Fan

Label Placement

Remove light lens by pressing in on the sides and pulling down. Remove the light bulb. Remove the light reflector and grille by removing the center acorn nut. The model label is located on either the inside perimeter of housing or underside of motor plate.

Powered Attic Ventilators

Label Placement

The model label is located on the cover of the wiring box which is visible from the attic.

Utility Ventilators

Label Placement

Removed the grille by a central knob or two screws. The model may be ceiling or wall mounted. The label is located on the inside perimeter of housing opposite wiring panel.

Trash Compactor

Label Placement

The model may be free standing or installed under cabinet. The label is located inside on the right wall of housing at the motor level, access through rear service panel if drawer cannot be removed.

All Broan 12" wide compactors use the same bags. Orders can be placed using Part #93620008 (12 pack).

All 15" wide units use bag #15TCBL (12 pack).

Heaters

Label Placement

Remove the grille by unhooking the springs from the housing.  The model number can be found inside the housing on a specification label.